Boom Lift Safety Training Victoria

Boom Lift Safey Training Victoria - Boom lifts fall under the type of elevated work platform or aerial lifting device. Most normally used in construction, industry, and warehousing; the boom lift is very versatile that it could be used in practically any environment.

Elevated work platforms enable personnel to access work areas which will be inaccessible otherwise. There is inherent danger in the operation of these devices. Workers who operate them must be trained in the correct operating methods. Accident prevention is vital.

Boom Lift Training Programs cover the safety aspects involved in using boom lifts. The program is best for those who operate self-propelled boom supported elevated work platforms and self-propelled elevated work platforms. Upon successfully completing the course, Those who participated would be issued a certificate by someone qualified to verify the completion of a hands-on assessment.

Industry agencies, federal and local regulators, and lift manufacturers all play a role in establishing standards and providing information so as to help train operators in the safe use of elevated work platforms. The most important ways to avoid accidents associated to the use of elevated work platforms are as follows: having on safety gear, performing site assessment and checking machinery.

Important safety considerations when operating Boom lifts:
Operators must observe the minimum safe approach distance (or also called MSAD) from power lines. Voltage can arc across the air to find an easy path to ground.

A telescopic boom should be retracted prior to lowering a work platform so as to maintain stability when the platform nears the ground.

Personnel working from the Boom lift platform must tie off to guarantee their safety. lanyard and safety harness combinations must not be attached to any anchorage other than that provided by the manufacturer, never to other poles or wires. Tying off may or may not be needed in scissor lifts, that depends on specific job risks, local rules, or employer guidelines.

The maximum slope will be specified by the manufacturer. Workers must avoid working on a slope, if possible. When the slope is beyond recommended conditions, the lifting device must be transported or winched over the slope. A grade could be measured without problems by laying a straight edge or board of at least 3 feet on the slope. Afterward a carpenter's level could be laid on the straight edge and the end raised until it is level. The percent slope is obtained by measuring the distance to the ground (likewise called the rise) and then dividing the rise by the length of the straight edge. After that multiply by one hundred.

Click to Download the pdf